No products in the cart.
6 meter 300 W Low Loss Bandpass Filter BPF
50 MHz Band-pass Filter BPF uses high Q coils and capacitors with Q more than 4000. Low loss of the filter is achieved with careful design and adjustment.
Intended to be used with linear amplifiers up to 300 W output.
Although this filter is intended to be used as a transmitting filter, its design also allows is to be used as a receiving filter. It can be used before Wide Band LNA with PGA-103+ to protect sensitive device from strong out-of-band signals.
Low Insertion loss filter is excellent to be placed before any LNA to protect the receiver from HF transmitters in DX expeditions or in multi-multi environment. This BPF will suppress any harmonic on 100 MHz, 150 MHz and more, and it will protect it from HF stations.
This Band-Pass filters is good for receiving as well for transmitting, works very well both ways.
External appearance of the filter:
The recorded data on the assembled filter with HP8753ES full 2-port calibrated are presented below.
Measured Return Loss (S11) and Insertion Loss (S21). Characteristics of 50 MHz Bandpass filter for up to 300 W transmitter.
|Achieved results on build Band-pass Filter (Attenuation)
Bandwidth: 50 – 51 MHz
144 MHz / 432 MHz Band Attenuation
These excellent results were achieved by careful selection of components and design of the filter. Band Pass filter will eliminate any harmonic emission from your linear amplifier.
More measured results with HP8753ES network analyzer full two port calibrated:
1. Measured HF attenuation:
2. Measured FM and VHF attenuation:
3. Measured UHF attenuation:
Feel free to send e-mail if you need something more specific.
All band-pass filters are here: HF, VHF and UHF Band-Pass Filters
Direct link to all 6 meter filters. We have 50 W, 100 W, 200 W, 300 W, 1500 W and 4000 W versions: 6 Meter Band-Pass Filters