6m 2el Rear Mount Antenna 6m2DXR

6m 2el Rear Mount Antenna 6m2DXR


6m 2el Rear Mount Antenna 6m2DXR 50-50.5MHz

SKU: 0105 Category:

6m 2el Rear Mount Antenna 6m2DXR 50-50.5MHz

50 MHz 6m 2el Rear Mount Antenna 6m2DXR for balcony or tower side use. Perfect for field days with lightweight construction or even for permanent setup.

This 6m 2el Rear Mount Antenna 6m2DXR has the widest possible azimuth radiation pattern. Good for vertical stacking in a permanent setup since this wide angle allows listening to ham radio stations without frequent rotator movement. It is good for the E-sporadic season since where you don’t need much gain.

The old name of the antenna was PA50-2-1.4RB


6m 2el Rear Mount Antenna 6m2DXR balun and dipole view.

50 MHz 2 element Rear Mount Antenna 6m2DXR. Dipole, Balun and Connector View


What does 6m2DXR mean?

  • 6m – 6m Magic band antenna
  • 22 elements
  • DX – Covers DX part of 6m band 50-50.5MHz with low SWR
  • RRear mount


Electrical specifications of 6m 2el Rear Mount Antenna 6m2DXR

Frequency Range: 50 – 50.5 MHz
Free Space Forward Gain: 6.2 dBi
Front-to-Back Ratio: 10 dB
-3 dB Horizontal Beamwidth: 68.4°
Polarization: Horizontal
Nominal Input Impedance: 50 Ohm
SWR Across Entire Band: < 1.2
Maximum Power Input: 1000 W (more by request)
Matching Method: Direct feed through common mode choke (current balun)
Connector: “N” (Silver plated Teflon SO 239 or 7/16 DIN by request)


Power input options by order of DX Contest Antenna 6m2DXR

“P” – Power version “N” Input connector RG142 5mm Teflon balun cable: 1500W 6m2DXRP
“E” – Extra power 7/16 DIN Input connector SF250 7mm Teflon balun cable: 3500W 6m2DXRE
“EX” – EXtreme power 7/16 DIN Input connector RG115 10mm Teflon balun cable: 8000W 6m2DXREX


6m2DX1R 2elements 6meter Rear Mount Yagi Antenna Wide Angle


Mechanical specifications of 6m 2el Rear Mount Antenna 6m2DXR

Number of Elements: 2
Tapered elements. Center tube 12mm, extensions 10 and 8mm
Tapered dipole. Center tube 12mm, extensions 10 and 8mm
Balun and Connector: Included
Longest Element: 3.1 meter
Element Mounting Position: Below the boom
Boom Length: 1.4m
Boom Size: 30x30mm
Number of Boom Pieces: 1
Turning Radius: 2 meter
Guy rope support: Not necessary. Strong boom
Mounting Mast Diameter: 43 – 70 mm 1-11/16″ – 2-3/4″ OD
Clamp: M8 Stainless Steel
Survival Wind Speed: 160km/h
Net Weight: 1.5 kg
Gross Weight: 2.7 kg
Transportation Length: 1.49 meter


6m2DXR Two antennas vertical stacking distances:

2.75m, Gain 9.3dBi, F/B 18.6dB (+3 dB)
3.2m, Gain 9.8dBi, F/B 21.6dB (+3.5 dB)
3.5 m, Gain 10dBi, F/B 16dB (+3.7 dB)


6m2DXR Four antennas vertical stacking distances:

2.55m, Gain 12.1dBi, F/B 17dB (+5.8 dB)
2.7m, Gain 12.3dBi, F/B 19dB (+6 dB)
2.95m, Gain 12.6dBi, F/B 25dB (+6.3 dB)
3.2m, Gain 12.9dBi, F/B 26dB (+6.6 dB)


Antennas-Amplifiers Product Benefits. A Major advance in Amateur Radio antenna design.


  • F/B and G/T superiority.

All antennas have been calculated using state-of-the-art full 3D Electromagnetic Simulation Software including the influence of the boom, bracket, baluns, and connectors. The performance of antennas designed using these techniques is exceptional, far better than antennas designed using “wire” programs.
Comparison of EM simulation software

  • No tuning antennas

Before dispatch, we assemble each antenna and test antenna characteristics. That means you may expect exceptionally good electrical and mechanical performance including low SWR across the designed range immediately after assembling.
No need to tune the dipole, or any other element to get perfect SWR on the intended frequency range. Everything is pre-tuned.

  • Easy to set up

Everything is labeled, just put number to number. The antenna can be assembled with hand tools.
Everything is included in the antenna box: Antenna, balun with connector, and bracket. Yours is to assemble and have fun!


Look at all 6m antennas: 6m antennas


Weight 2,7 kg
Dimensions 119 × 11 × 10 cm


There are no reviews yet.

Be the first to review “6m 2el Rear Mount Antenna 6m2DXR”