23cm Low Noise Yagi 18elements 23cm18DXRA 1290-1310MHz

23cm Low Noise Yagi 18elements 23cm18DXRA consists of two boom parts. So the max length of any piece is less than 1m. Perfect for a car, airplane transport, or balcony mount. The antenna is tested before dispatch and comes fully assembled. Just take out of the box. Ready in a minute.

 

23cm Low Noise Yagi 18elements 23cm18DXRA Appearance:

 

What does 23cm18DXRA mean?

• 23cm – Frequency range from 1290 to 1310 MHz with low SWR
• 18 – 18 Elements
• DX– For use in the DX part of the band
• R – Rear mount
• A – Boom parts up to 118cm or 47″ for Airplane “checked baggage” length

 

Electrical Specifications of 23cm Rear Mount Antenna 18elements 23cm18DXRA

Frequency Range: 1290 – 1310 MHz (by order 1240 – 1310 MHz)
Free Space Forward Gain: 17.3 dBi
Front-to-Back Ratio: 29 dB
-3 dB Horizontal Beam-width: 24.4°
Polarization: Horizontal (Vertical by order)
Nominal Input Impedance: 50 Ohms
SWR Across Entire Band: < 1.2
Maximum Power Input: 100 W (more by request)
Matching Method: Voltage balun. Voltage Balun RG-316 Teflon Cable
Connector: “N”

 

Mechanical Specifications of 23cm Rear Mount Antenna 18elements 23cm18DXRA

Number of Elements: 18
Element Diameter: 4 mm Aluminum rod
Dipole Diameter: 3 mm Copper
Longest Element: 120 mm
Element Mounting Position: Below the boom
Balun and Connectors: Included
Boom Length: 1.46 m
Boom Size: 20×20 mm
The number of Boom Pieces: 1
Mounting Mast Diameter: 43 – 70 mm 1-11/16″ – 2-3/4″ OD
Bracket: Goliath – Stainless Steel AISI 316L (A4), 2 x M8 Stainless Steel
Survival Wind Speed: 150 km/h
Net Weight: 1.1 kg
Gross Weight: 2.9 kg
Transportation Length: 1.5m

The old name of the antenna was PA1296-18-1.5RA

 

Video about assembling: https://youtu.be/SmIm5lYmlZo?feature=shared

 

Antennas-Amplifiers Product Benefits. A Major advance in antenna design.

• F/B and G/T superiority.

All antennas have been calculated using state-of-the-art full 3D EM modeling software, including the influence of the boom, bracket, baluns, and connectors. The performance of antennas designed using these techniques is exceptional, far better than antennas designed using the EZNEC program.

• No tuning antennas. 

Before dispatch, we assemble and test each antenna’s characteristics. No need to tune any element to get a perfect SWR on the intended frequency range. Everything is pre-tuned.

• Easy to set up. 

Everything is labeled, just put a number to a number. Everything is included in the box: Antenna, balun, bracket, and guy rope support if needed. Yours is to assemble and have fun!

• Mechanical properties.

We believe that our antennas are the world’s strongest and are mechanically constructed much better than any antennas from other manufacturers.

 

Check the other 23cm antennas: 23cm antennas